New to this thread, not sure if it's even active... I put in the 3 rpm auger motor from smokedaddy, had to push the auger in about 3/4 inch towards hopper, put a steel shim underneath in place of the bracket. Runs fine, MFR set at 20, no temp offset, held 180, held 200, 250 steady. Cold start...
Finally got my local tailor to sew in a zipper onto front left corner of my bull cover. Works like a charm, much easier on/off. Here's link to zipper and a pic. Total cost about $35 maybe a bit much but then again I can't sew...
Hi All - I recently (accidentally) removed the light housing from my Bull while trying to temporarily remove the light cover. I already had everything off when I realized that the lens just pops off for cleaning. Anyway, in the process of trying to get it back in I accidentally broke the wires...
Got this one (2 pack) on Amazon and was simple to install, did while assembling new. Connects IMMEDIATELY to wifi now across the yard. I'll send you the extra one for $5 venmo me haha. Sorry couldn't get the link to work (y)
Mine is in transit now and I almost bought the wheels and other items from the OP but held off. Glad I saw this post! I am NOT an engineer so hopefully one of you wizards will come up with a quick solution to get the bigger wheels to work. Is the issue that the existing receptacle for the wheel...
I agree 150%!! My Bull has been on quite the "journey" on it's way up to southern NJ... Estes handed off to a local agent for residential delivery and that was a week ago. Ashly B at RECTEC shipping has been on the case and has called me daily to update me. Not their fault, but they CARE, and...