Mlmurrah
Well-known member
- Messages
- 110
- Grill(s) owned
- Bull
I replaced the auger access panel (the cubical shroud under the pellet hopper) that was bent in shipping and had no problem doing so. There ware holes drilled for the serial number placard, but I can't figure out how to remove it from the old panel. At first I thought it was held on by screws, but upon closer examination it appears that they are rivets. The only way. know to remove them is to grind them off with a die grinder and replace them with screws or bolts. I need a sanity check here. Is thare a better way to remove them?