Distilled1
Member
- Messages
- 10
- Location
- Evans Georgia
So I finally bit the bullet and picked up a Patio 410 got it put together spent 5 hours trying every trick and tip to get this thing to connect. nothing (waiting on support to get back to me) this model has Firmwear Uer503 and is sold as dual band 2.4/5G the controller is less than 10 foot from an EERO access point the app will say 5 Ghz may not work and never moves on connect stays at 0% and then gives an error page - I have set my eero's to 2.4 only reconnected the phone via 2.4 same thing happens only difference is I don't get the little ! 5Ghz warning on the connection screen. *even took the whole smoker into the house and tried right at the main router its like its not even seeing anything. only thing I am unable to test is with a hot spot as cell service is horrible here.
Any tips ?
The whole reason I chose this model was for the wifi being dual so it wouldn't have all the issues many 2.4 only devices have- and so I could set the temp etc.
A
#2 while doing the burn off sett at 400f why is this thing ruining actual temp of 590+ after the burn off set t o 375 and it wouldn't hit 375 dropped to 325. Being as I don't have the app to use and the manual is a lacing POS with what to set I don't know if this is what it should be but I thought for sure it would hold a set temp better than my offset stick burners.
Any tips ?
The whole reason I chose this model was for the wifi being dual so it wouldn't have all the issues many 2.4 only devices have- and so I could set the temp etc.
A
#2 while doing the burn off sett at 400f why is this thing ruining actual temp of 590+ after the burn off set t o 375 and it wouldn't hit 375 dropped to 325. Being as I don't have the app to use and the manual is a lacing POS with what to set I don't know if this is what it should be but I thought for sure it would hold a set temp better than my offset stick burners.