Stratmeister
Active member
So I’ve done several cooks on my Bull at this point. I always keep a ThermoWorks Signals alongside the Bull probes due to outages, etc...
But my question is with the main temp probe. A calibrated and trusted Signals probe consistently reads 20 degrees lower than the Bull thinks the pit is.
You guys have this offset? What would you do, just remember the pit is 20 lower and bump the Bull by 20 degrees? Can the probe be adjusted that much to make it more accurate? Just don’t worry about it and use the Signals? Just don’t consider it at all? And if so any adjustments to feed rate required?
Thinking out loud really...
But my question is with the main temp probe. A calibrated and trusted Signals probe consistently reads 20 degrees lower than the Bull thinks the pit is.
You guys have this offset? What would you do, just remember the pit is 20 lower and bump the Bull by 20 degrees? Can the probe be adjusted that much to make it more accurate? Just don’t worry about it and use the Signals? Just don’t consider it at all? And if so any adjustments to feed rate required?
Thinking out loud really...